Finisher: Add Staples - Oce VarioPrint 4110 User Manual

Finisher: Add staples

Finisher: Add staples
Introduction
The optional finisher
your jobs. The finisher contains 2 staplers. Both staplers are located inside the finisher.
Stapler 1 is located at the back side. Stapler 2 is located at the front side.
This section describes how to add staples.
When to do
When a staple cartridge is empty or almost empty
on page 173.
Note:
You can add short and long staples. It is important to add the correct staples. Use short
staples when your documents contain upto 50 sheets. Use long staples when your docu-
ments contain more than 50 sheets. Only use staples of type S25 (long staples) or S37
(short staples).
Get access to the staplers
Open the front door of the finisher.
1.
Open top cover E1.
2.
Open cover E5.
3.
Lock cover E5 with the locking mechanism E6.
4.
If required, slide stapler 1 to the centre. This makes the access to the cartridge holder in
5.
stapler 1 easier.
Add staples
Remove the cartridge holder from the stapler.
1.
250 Chapter 7 - Keep the printer running
'The output locations' on page 32 on top of the stacker can staple
'Check the status of the staple cartridges'