Lubricate The Die Sets - Oce VarioPrint 4110 User Manual

Lubricate the die sets

Lubricate the die sets
Introduction
The die sets have a life expectancy of approximately 500,000 punched sheets. However,
when you lubricate the die sets on a regular basis, the life expectancy can increase. You
must regularly lubricate the following parts.
The punch pins.
The shoulder bolts and springs.
The felt oil pad, if applicable.
Some die sets have a felt oil pad that must be lubricated. The following table indicates
which types of die set do or do not have a felt oil pad.
Types of die sets with and without a felt pad
Type
1
2
3
When to do
Lubricate the punch pins every 50,000 punched sheets.
Lubricate the shoulder bolts and springs every 200,000 punched sheets.
Required tool
Use a high quality machine oil to lubricate the die sets.
Attention:
Do not use an aerosol (spray) type of oil. This type of oil leaves a sticky residue on the
pins and attracts paper dust.
Note:
See 'Replace a die set' on page 234
set into the die set slot.
238 Chapter 6 - Optional finishers
Description
No felt oil pad
A felt oil pad on 1 side, includ-
ing a magnet and retaining plate
A felt oil pad surrounds the
punch pins
for information about how to remove and insert a die
#
Die sets
2-, 3-, 4-Hole and VeloBind
2:1 and 3:1 Wire (round and
square holes)
19-, 20-, 21-Hole comb
44-, 47-Hole coil
®