Correct An Image - Oce VarioPrint 4110 User Manual

Correct an image

Introduction
When you carried out a scan job, you can check the result. The situation can occur that
the scan results are not correct. The table below displays problems that can occur and
offers a solution.
Correct an image
Correct an image
Description of the
problem
All the pages are upside
down
Every second page is
upside down
All the pages are posi-
tioned sideways
The information on the
page is too large or too
small
#
Solution
You put the originals in the wrong direction in the automat-
ic document feeder or on the glass plate.
Scan the originals again and make sure the originals are
correctly placed (see
the ADF' on page
The 'Original type' settings that you selected do not corre-
spond with the orientation of the information on the orig-
inals.
Scan the originals again and select the correct 'Original
type' setting.
There is more than 1 explanation for this problem.
Wrong orientation selected
Original feed direction confused with the orientation
of the information on the original
The application you use does not process the TIFF/PDF
file in the right way.
Scan the originals again and select the correct 'Original
type' setting. If the problem remains, the application you
use can be the cause of the problem. Check the results in
another application.
This problem can occur when the size of the original and
the selected size of the target scan are not the same. The
problem can also be caused by a (manual) change in the
zoom factor.
Scan the originals again and check the size of the 'Original'
and the 'File' on the operator panel (see
file' on page
'Original input on the glass plate or into
100).
141).
Chapter 4 - Work with the operator panel
Correct an image
'The scan profiles
157