Check and change the job properties
Change the number of sets
Introduction
Note:
This section applies to changing the settings of a print job or copy job that is already
available in the list of 'Waiting jobs' or 'Scheduled jobs'.
When a job is sent to the machine, the desired number of sets will be indicated. However,
you can change the number of sets on the operator panel.
This section describes how to change the number of sets for a specific job.
Note:
You can enter any value between 1 and 65,000 for all jobs except the active print job .
To change the number of sets for the active print job , you must first press the Hold
key
1 time. Then you can change the number of sets. You cannot define a lower value
than the number of sets that has already been printed.
Chapter 4 - Work with the operator panel
Change the number of sets
77