Punch Or Staple The Output - Oce VarioPrint 4110 User Manual

Punch or staple the output

Introduction
Your machine can be equipped with several finishing devices like the puncher or stack-
er/stapler. When your machine is equipped with one of these finishing devices, or both
devices, you can indicate the following on the operator panel:
The number of staples
Whether you want to punch the documents
The number of holes that the puncher makes depends on the die set that the puncher
contains.
This section describes how to punch or staple the output.
Note:
When you have a puncher and a stapling device installed, the required 'Output' setting
is called 'Finishing'.
When you only have a stapling device installed, the 'Output' settings is called 'Staples'.
When you only have a punching device installed, the 'Output' settings is called 'Punch'.
Chapter 4 - Work with the operator panel
Punch or staple the output
133