Create A Transaction Setup - Oce VarioPrint 4110 User Manual

Create a transaction setup

Create a transaction setup
Introduction
When you want to use transaction printing, you have to create the necessary transaction
setups. You can create these setups in the settings editor.
Note:
When the settings editor does not display the correct language, you can change the
preferred language in the internet options of your internet browser. The desired language
must be first in the list of languages.
How to create a new transaction setup
Go to 'Transaction Printing' - 'Setups' .
1.
Click the 'Add' button.
2.
A pop-up window appears.
Type in the name and the description of the transaction setup.
3.
Click 'Ok'.
4.
Put a checkmark in front of the transaction setup to select the setup.
5.
Click 'Open'.
6.
The status of the setup will change to opened.
Change the settings under the 'IPDS setup' tab (see
7.
on page 217).
You can change the settings:
by group (click the pencil at the right-hand side of the group settings). This is the
preferred method.
by item (click the pencil behind the individual settings).
Change the settings under the 'PCL setup' tab (see
8.
on page 217).
Change the values under the 'Settings' tab.
9.
Note:
The status of the setup is changed to modified. You have to load the setup to make these
modifications available on the printer.
Before you can load a transaction setup, you have to switch the transaction printing mode
off-line.
Go to 'Transaction Printing' - 'Settings', and click 'Toggle the transaction printing mode'
10.
to switch the printer off-line.
Go to 'Transaction Printing' - 'Setups', and click 'Load'.
11.
216 Chapter 4 - Work with the operator panel
'How to change the IPDS parameters'
'How to change the PCL parameters'