The Power Modes - Oce VarioPrint 4110 User Manual

The power modes

The power modes
Introduction
This section describes the power switches and the main power modes of the machine.
The table in this section describes, among other things, the low-power mode and the
sleep mode. These modes are energy save modes. You can set the timers for these modes
in the Settings Editor on the controller. Furthermore, you can set a calendar timer in the
Settings Editor. Then the machine will wake up from the sleep mode at the indicated
time. You can use the calendar timer for example to make sure that the machine is ready
for use at the beginning of your working day. The machine can warm up before you start
your working day.
Description of the power switch and the On/Off button
The machine has the following switch and button to control the power supply.
Power switch
The power switch is located behind the front door of the machine. The power switch
connects and disconnects the machine to the mains power.
On/Off button with amber and green LEDs .
The On/Off button on the machine (see
and finishing devices' on page
and the sleep mode. This is only possible if the power switch
and the start-up phase is completed.
Description of the main power modes
The main power modes
Power mode
Off
16 Chapter 2 - Power information
24) allows you to toggle between the stand-by mode
#
Description
The machine is completely off.
The power switch is in the 'O'
position. There is no power
consumption. The machine
cannot receive or print jobs.
'Introduction to the main system components
Status of the
On/Off button
Off
is in the '1' position
Status of the
Hold button
and Release
button
Off