Troubleshooting - Oce VarioPrint 4110 User Manual

Troubleshooting

Introduction
The main types of possible errors are the following.
Errors that relate to the machine
Errors that relate to the jobs
This section gives an overview of the possible errors and the solutions to these errors.
Note:
Only operators who received the special maintenance training are allowed to replace or
clean parts and solve paper jams in the process units.
Overview of the possible machine errors
Handle the machine errors
Error
Paper jam
Software error
Service re-
quired
Unit recondi-
tioning
The system
cannot deter-
mine if the
output is com-
plete
#
Solution
Follow the instructions
on the operator panel.
Follow the instructions
on the operator panel.
Follow the instructions
on the operator panel.
Follow the instructions
on the operator panel.
Follow the instructions
on the operator panel
and check the output.
Additional information
After you solved the error, the machine
starts from the point where the printing
stopped due to the error. Please check for
double prints.
A message on the operator panel will indi-
cate that you must restart the machine.
A message on the operator panel will indi-
cate that you must call Service.
After an error was solved, the machine
checks if the print job can continue from
the point where the printing stopped.
When you use cyclic media, you must
probably remove a couple of sheets.
The system can sometimes not determine
if the output is complete. Then you must
check the output. Press the 'OK' button
when the output is complete.
Chapter 7 - Keep the printer running
Troubleshooting
261