The Zoom Behaviour - Oce VarioPrint 4110 User Manual

The zoom behaviour

The zoom behaviour
Introduction
When you carry out a copy job or scan job, you can use the 'Zoom' function to reduce
or enlarge an image, for example:
Copy an A4 original on an A3 sheet. The system enlarges the image
Copy an A3 original on an A4 sheet. The system reduces the image
Copy an A4 original with a small illustration on an A4 sheet, and at the same time
enlarge the illustration.
By factory default, the zoom function is set to 'Fit to page'. This makes sure that no in-
formation is lost. To change the zoom factor manually, press the - and + buttons of the
'Zoom' function in the job window. When you use non-standard size originals, you must
use the glass plate. The scanner can not automatically detect the size of the originals on
the glass plate. Therefore, you must select the original size manually.
The zoom function for originals in the automatic document feeder is different from the
zoom function for originals on the glass plate.
Zoom behaviour
Original
Automatic document feeder
Glass plate
This section describes the characteristics of the zoom function when you use the automatic
document feeder or the glass plate.
Note:
The zoom function works identical for both copy jobs and scan jobs.
Scan from the automatic document feeder and use the zoom function
The following table shows the zoom behaviour of the machine when the originals are
scanned from the automatic document feeder. The focus is on the centre of the original.
106 Chapter 4 - Work with the operator panel
#
Starting point of the zoom function
Centre
Upper left-hand corner