The Dual Paper Tray (Optional) - Oce VarioPrint 4110 User Manual

The dual paper tray (optional)

Introduction
Task for operators, key operators
The dual paper tray is an optional high-capacity paper tray. You can use a dual paper tray
instead of a standard bulk tray. A standard bulk tray can contain up to 1,700 sheets. A
dual paper tray can contain 2 stacks of paper (A4 LEF or Letter LEF). The total capacity
of a dual paper tray is about 3,400 sheets.
The following procedures describe how to replace the bulk trays with dual paper trays,
and the other way round.
Note:
Do not fill the dual paper tray above the maximum levels as indicated on the 2 stickers
inside the paper tray. Put the left-hand paper stack fully against the left edge. Put the
right-hand paper stack fully against the right edge.
Before you begin
Make sure that the paper tray you want to replace is empty.
Note:
When the dual paper trays are installed for the first time, a number of adjustments are
required. Therefore, Océ service technicians will do the initial installation.
Caution:
The bulk trays and the dual paper trays are heavy. Always remove and install the bulk
trays and the dual paper trays with 2 persons.
How to remove a bulk tray or dual paper tray
On the operator panel, select the 'Trays' view.
1.
Press the paper tray where you want to install the dual paper tray.
2.
Press 'Open'.
3.
The rails on both sides of the paper tray contain 2 orange stickers with an arrow.
Slide the paper tray out until you see the first orange sticker.
4.
A spring-lock is situated next to the sticker.
Chapter 3 - Overview of the system components
The dual paper tray (optional)
37