Table of Contents
Advertisement
Make a basic copy
Make a basic copy
Introduction
You can use the copy function of the machine to carry out all kinds of copy jobs. Copy
jobs can vary from basic one-to-one copy jobs without subsets to more advanced jobs
with subsets (see
basic copy, all the settings that you make apply to the whole document.
This section describes how to make a basic copy that the machine prints as soon as possible.
Before you begin
Remove all staples from your originals.
Remove the paper clips.
Make sure that the originals in the automatic document feeder have the same size.
Make sure that the automatic document feeder does not contain more than 75 sheets
(80 g/m² or 20 lb bond).
Make sure that the originals are not curled.
Note:
The machine contains a function called double-sheet detection. This function checks
whether the originals in the automatic document feeder are separated and scanned one
by one. When sheets stick together, the operator panel displays a warning:
'<HTML>Check the originals: a double sheet is detected.</HTML>'. By default, this
function is enabled. However, when you copy or scan paste-up originals, it can be con-
venient to disable the double-sheet detection (see
page
197).
118
Chapter 4 - Work with the operator panel
'Combine subsets into one document ' on page
120). When you make a
'Disable the double-sheet detection' on
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
