Table of Contents
Advertisement
Change the type of offset stacking
Change the type of offset stacking
Introduction
Note:
This section applies to changing the settings of a print job or copy job that is already
available in the list of 'Waiting jobs' or 'Scheduled jobs'.
You can use the function 'Offset stacking' to create a visible distinction between sets or
jobs in an output location. When 'Offset stacking' is enabled, each set or job will be
stacked with an offset compared to the previous set or job. You can set the default type
of offset stacking in the workflow profile on the operator panel (see
workflow profiles' on page
type of offset stacking for specific jobs.
Possibility to change the type of offset stacking per job
When
The type of offset stacking is set to
'<html>Sets (as in job)</html>'
The type of offset stacking is set to
'<html>Jobs</html>', '<html>Sets (al-
ways)</html>', '<html>Banners</html>'
or '<html>Off</html>'
This section describes the following.
The values you can select in the 'Properties' window when '<html>Sets (as in
job)</html>' is set in the workflow profile
How to change the type of offset stacking per job via the 'Properties' window.
Types of offset stacking in the 'Properties' window
When '<html>Sets (as in job)</html>' is set in the workflow profile, then you can select
one of the following types of offset stacking.
Available types of offset stacking in the 'Properties' window
When
You select 'Each set'
You select 'Off'
92
Chapter 4 - Work with the operator panel
179). The following table describes when you can change the
Then
You can change the type of offset stacking
per job via the 'Properties' window in the
'Jobs' view.
You cannot change the type of offset
stacking per job. The 'Properties' window
displays the system value.
Then
All the printed sets are sent to the output
location with an offset between the sets.
All the printed sets are sent to the output
location in one straight stack.
'Work with the
#
#
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
