Oce VarioPrint 4110 User Manual page 217

The setup is now available on your operator panel.
How to change the IPDS parameters
Go to 'Transaction Printing' - 'IPDS setup'.
1.
Make sure that the Tray selection mechanism is set to Tray to Media.
2.
This is the preferred setting. This printer is a media-based machine. The Tray-to-media
method supports this behaviour.
Change the settings under the 'IPDS setup' tab.
3.
You can change the settings:
by group (click the pencil at the right-hand side of the group settings). This is the
preferred method.
by item (click the pencil behind the individual settings).
For 'IPDS Tray to media for media 1' assign the 'Media catalogue item' from the list.
4.
The list displays all the media in the media catalogue. The system copies the media at-
tributes from the selected media to the transaction setup.
When you assign A3/Ledger-like media or want to use short-edge feed for other media,
change the feed direction to 'Short-edge feed (SEF)'.
Note:
The settings editor displays only the media for which the media name is consistent with
the IPDS media name definitions. Valid characters for an IPDS media name are: A-Z,
a-z, 0-9, blank.
Repeat step 4 for all the logical trays in your setup.
5.
How to change the PCL parameters
Go to 'Transaction Printing' - 'PCL setup'.
1.
Make sure that the Tray selection mechanism is set to Tray to Media.
2.
This is the preferred setting. This printer is a media-based machine. The Tray-to-media
method supports this behaviour.
Change the settings under the 'PCL setup' tab.
3.
You can change the settings:
by group (click the pencil at the right-hand side of the group settings). This is the
preferred method.
by item (click the pencil behind the individual settings).
For 'PCL Tray to media for media 1' assign the 'Media catalogue item' from the list. The
4.
list displays all the media in the media catalogue.
Chapter 4 - Work with the operator panel
Create a transaction setup
217