Installing A Cd-Rom/Dvd-Rom Drive; Figure 108. Assembling The Cd-Rom/Dvd-Rom Drive And Carrier - Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual

12. Store the drive in an antistatic protective wrapper or in its original packaging.
13. Install a new CD-ROM / DVD-ROM drive into the carrier or slide the empty carrier into the
server.
14. Connect the front panel cable to the SCSI backplane board.
15. Re-install the top cover. For instructions, see "Removing the Top Cover", page 144.

Installing a CD-ROM/DVD-ROM Drive

1. Observe the safety precautions, warnings, and cautions described in
5.
2. Turn off all peripheral devices connected to the system.
3. Power down the system and unplug both AC power cords.
4. Remove the top cover. For instructions, see "Removing the Top Cover", page 144.
5. Remove the CD-ROM / DVD-ROM drive carrier from the server. For instructions, see
"Removing the CD-ROM/DVD-ROM
6. Remove the new drive from its protective wrapper, and place it component-side down on a
clean ESD-protected work surface.
7. Record the drive model and serial numbers in your Equipment Log. See
page 252.
8. Attach the SATA-to-IDE converter board to the CD-ROM/DVD-ROM drive. See letter "A" in
Figure 108.
9. Place the left side of the drive into the drive carrier. See letter "B" and "C" in the figure.
10. Press the DVD-ROM/CD-ROM drive into the carrier until it is firmly secured.

Figure 108. Assembling the CD-ROM/DVD-ROM Drive and Carrier

Drive", page 199.
A
"Safety Information", page
"Equipment Log",
B
C
TP01580
201