Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual page 90

Server Platform Utilities
User
: Only "benign" commands are allowed. These are primarily commands that read data
structures and retrieve status. Commands that can be used to alter BMC configuration, write
data to the BMC or other management controllers, or perform system actions such as resets,
power on/off, and watchdog activation are disallowed.
Operator
: All BMC commands are allowed, except for configuration commands that can
change the behavior of the out-of-band interfaces. For example, Operator privilege does not
allow the capability to disable individual channels, or change user access privileges.
Administrator
administrator can even execute configuration commands that would disable the channel that the
Administrator is communicating over.
Enable Serial Over LAN: Allows you to enable or disable the SOL access for the server.
When checked, all of the SOL access parameters are enabled and you can set them to the
appropriate values. When not checked, all of the SOL access parameters on this page are
disabled.
Serial Over LAN Privilege Level Limit: The SOL Privilege Level Limit dropdown list allows
you to set the SOL privilege level that is required to be able to activate SOL mode using the
Activate SOL command. This privilege level takes precedence over the user privilege limit. If
the privilege level is set at User level, for example, then users can only execute user-level
commands, even if the user privilege level is set higher than User. The possible privilege level
choices are the same as the LAN Privilege levels.
SOL Number of Retries: The SOL Number of Retries edit box allows you to enter the number
of connection retries permitted while attempting access in SOL mode. The valid range is from
one to seven.
SOL Retry Interval: The SOL Retry Interval edit box allows you to enter a number for
specifying the interval between two retries while attempting access in SOL Mode. The valid
range is from one to 255.
SOL Baud Rate: The SOL Baud Rate dropdown list allows you to set SOL baud rate desired.
The valid choices are 9600bps, 19.2kbps, 38.4kbps, 57.6kbps or 115.2kbps.
90
: All BMC commands are allowed, including configuration commands. An
Intel® Server Platforms SR6850HW4 and SR6850HW4/M Product Guide