Hot Insertion Of A Memory Board; Figure 80. Installing Memory Board - Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual

User Serviceable Platform Components
NOTE
If you fail to follow the proper Hot Plug Remove process you must unlock
the memory module by unlatching the handle shown in the figure above. By
pulling the handle, power to the slot will be immediately disabled. The
"surprise hot remove" action may cause an operating system crash, but will
not electrically damage the system.

Hot Insertion of a Memory Board

1. Add or replace memory DIMMs as needed. For instructions, see
DIMMs", page 166.
2. Ensure the handle on the memory board is in the open / up position.
3. Align the ends in the card guides and slide the memory board into the memory board slot. See
letter "A" in Figure 80.
4. Push the handle down into the fully-locked position. See letter "B" in the figure.
5. Press the attention button to power on the memory board.
6. Install the top cover. For instructions, see
164
"Installing the Top
B

Figure 80. Installing Memory Board

Intel® Server Platforms SR6850HW4 and SR6850HW4/M Product Guide
"Removing and Installing
Cover", page 140.
A
TP01454