Installing The Scsi Backplane Board; Figure 119. Installing The Scsi Backplane Board - Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual

Servicing the Server Boards

Installing the SCSI Backplane Board

1. Observe the safety precautions, warnings, and cautions described in
5.
2. Remove the SCSI backplane board. For instructions, see
Board", page 214.
3. Lower the SCSI backplane board over the three tabs at the lower edge of the board.
4. Move the board until it is vertical, ensuring all ten tabs are through the slots in the SCSI board.
5. Slide the board downward, engaging all hooks.
6. Ensure the plunger is fully seated.
7. Install the main board. For instructions, see
8. Install the center brace. For instructions, see
9. Install all add-in cards. For instructions, see
You may use these instructions for hot-swap cards as well as non-hot-swap cards.
10. Install all memory boards and memory board air baffles. For instructions, see
of a Memory Board", page 165.
11. Connect the cables you disconnected during the removal process from the SCSI backplane
board. For connection locations, see Figure 86.
12. Install the top cover. For instructions, see
13. Install the hot-swap hard drives and hard drive carriers. For instructions, see "Installing a Hard
Disk Drive Assembly", page 146.
216
D
B C

Figure 119. Installing the SCSI Backplane Board

"Installing the Main
"Installing a Non-Hot-Plug PCI
"Installing the Top
Intel® Server Platforms SR6850HW4 and SR6850HW4/M Product Guide
"Safety
"Removing the SCSI Backplane
A
Board", page 213.
"Installing the Center Brace", page 177.
Cover", page 140.
Information", page
TP01571
Card", page 155.
"Cold Insertion