Installing Dimms - Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual

Installing DIMMs

CAUTIONS
Use extreme care when installing a DIMM. Applying too much pressure can
damage the connector. DIMMs are keyed and can be inserted in only
one way.
Hold DIMMs only by the edges. Do not touch the components or gold edge
connectors.
Install DIMMs with gold-plated edge connectors only.
The maximum DIMM height is 4.445 cm (1.75 inches). Do not install
DIMMs that exceed this height.
NOTE
DIMM slots on the memory module must be installed only in certain
configurations. Numbers next to DIMM slots correspond to installation
sequence. DIMMs must be installed by groups of two.
1. Remove the top cover. For instructions, see
2. Remove the memory board. For instructions, see
161, or "Cold Removal of Memory
configuration
3. Remove the memory board DIMM cover from the memory board:
- Pull out on the latch labeled "A" in Figure 82.
-
Press on the tab labeled "B" in the figure.
- Press on the tab labeled "C" in the figure.
-
Lift the memory board DIMM cover from the memory board. See letter "D" in the figure.
"Removing the Top
"Hot Removal of a Memory
Board" on page 165, depending on your server
Cover", page 139.
Board" on page
167