Installing Or Removing A Dvd-Rom Or Cd-Rom Drive; Installing A Dvd-Rom Or Cd-Rom Drive; Figure 34. Locating Active Heatsink Cable Connections - Intel SC5650SCWS Service Manual

Hardware Installations and Upgrades
6. Using a #2 Philips* screwdriver to tighten each fastener diagonally according to the white, circled numbers in Figure 33.
(Step "C" in Figure 33).
7. Securely re-tighten each fastener again in the same order as performed in Step 6. (Step "D" in Figure 33.)
Callout
A.
8. Attach the active heatsink fan cable to the workstation board. (Step "E" in Figure 33). See Figure 34 to locate the
processor fan headers.
9. Reinstall and reconnect any parts you removed or disconnected to reach the processor sockets.
10. Replace the fan duct, hard disk cage, and chassis cover. Reconnect the AC power cord.

Installing or Removing a DVD-ROM or CD-ROM Drive

CAUTIONS
CD-ROM and DVD-ROM drives are NOT hot-swappable. Before removing or replacing the drive, you must first take the
Workstation out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power
button, and unplug the AC power cord from the system or wall outlet.

Installing a DVD-ROM or CD-ROM Drive

1. Observe the safety and ESD precautions listed in Appendix A,
2. Power down the workstation and unplug all peripheral devices and the AC power cable.
Intel® Workstation System SC5650SCWS Service Guide
Processor Heatsink Connector
CPU_1

Figure 34. Locating Active Heatsink Cable Connections

Callout Processor Heatsink Connector
B. CPU_2
"Safety Information".
42