Installing And Removing A 5 ¼-Inch Peripheral; Installing A 5 ¼-Inch Peripheral - Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual

Installing and Removing a 5 ¼-inch Peripheral
Installing a 5 ¼-inch Peripheral
1. Observe the safety precautions, warnings, and cautions described in
2. Turn off all peripheral devices connected to the system.
3. Power down the system and unplug both AC power cords.
4. Remove the top cover. For instructions, see "Removing the Top Cover", page 144.
5. Push the tabs at each side of the carrier filler panel. See letter "A" in Figure 110.
6. Hold the tabs in while pulling the carrier filler panel from the bay. See letter "B" in the figure.
Figure 110. Removing 5 ¼ Peripheral Filler Panel from Server
7. Remove the screws that attach the slide rails to the filler panel.
8. Attach the slide rails to the device using the screws removed from the filler panel.
9. The filler panel is not reinstalled. Retain the filler panel for possible future installation.
10. Pull the Y-power cable through the 5 ¼ peripheral opening.
11. Attach the Y-cable to the 5 ¼ peripheral.
A
"Safety Information".
B
TP01552
203