Removing A Non-Hot-Plug Pci Card - Intel SR6850HW4 - Server Platform - 0 MB RAM Product Manual

User Serviceable Platform Components
13. Install the top cover. For instructions, see

Removing a Non-Hot-Plug PCI Card

PCI cards installed in slots 1 through 5 are hot-swappable. If you are adding or removing a card
from one of these slots, you can do so without powering down the server. If you wish to do so,
follow the instructions under
Interface" on page 149, or
page 151, and "Installing a Hot-plug PCI Add-in
CAUTION
Damage to the system occurs if power is not removed from the system prior
to removal or installation of non-hot-plug boards.
1. Observe the safety precautions, warnings, and cautions described in
5.
2. Turn off all peripheral devices connected to the system.
3. Power down the system and unplug both AC power cords to remove power from the server.
4. Remove the top cover. For instructions, see
5. Disconnect any cables attached to the PCI card.
154
"Installing the Top
"Removing Hot-plug PCI Card with Operating System Hot-Plug
"Removing Hot-plug PCI Card with Hardware Hot-Plug
Card", on page 152.
"Removing the Top
Intel® Server Platforms SR6850HW4 and SR6850HW4/M Product Guide
Cover", page 140.
Interface" on
"Safety Information", page
Cover", page 139.