Micromeritics Elzone II 5390 Operator's Manual page 321

Appendix A
6200 Series
6200- The file (file name) does not have background data.
Cause:
Action:
6201- The file (file name) does not have full-resolution data.
Cause:
Action:
6202- Graph is not available. The orifice tube was not calibrated.
Cause:
Action:
6203- No data available in file (file name) for reporting.
Cause:
Action:
6204- The file (file name) does not have pulse length data.
Cause:
Action:
539-42822-01 (Rev A) - Nov 2017
You selected a background report for a file that contains no background
data.
Click on the Collected Data dialog and select a back-
Data Setup
ground file.
You selected a pulse length or pulse length vs. particle size report for a
file that does not contain full-resolution data. This information either
was not collected or has been deleted.
Before analysis, select Full resolution data on the Data Setup dialog
(from the Analysis Conditions dialog). Do not delete full-resolution
data if you wish to produce these type of reports.
You requested an orifice tube calibration report for an orifice tube that
has not been calibrated.
Calibrate the orifice tube, then request the report again.
You requested a report for a file that does not contain collected data.
Use the file in an analysis before requesting reports.
You requested a pulse length report for a file that contains entered data.
Choose a report containing full-resolution data; pulse length reports are
only available for this type of data.
Elzone II 5390 Confirm
A-45