Micromeritics Elzone II 5390 Operator's Manual page 300

Elzone II 5390 Confirm
4200 Series
4200- An error occurred while loading the application control information. Data entry
cannot be performed. (Code # <number>)
Cause:
Action:
4201- No reports selected.
Cause:
Action:
4202- No valid data to report.
Cause:
Action:
4203- The reference file is not valid. 'Diff. from ref.' column was deleted.
Cause:
Action:
A-24
An internal error occurred while read control information was being
read from a disk file.
The disk on which the application is installed may have failed. Contact
your Micromeritics service representative and report the code number
given in the message.
You failed to select reports in the Reports to Generate list box. No
output could be produced.
Ensure that at least one report is selected for the sample and re-submit
the sample for reporting.
The selected analysis in the sample file activated for reporting does not
contain any valid data.
If the sample is still analyzing, wait until enough data have been col-
lected to allow reporting. If the sample is complete, an error or operator
intervention stopped this analysis before sufficient data could be col-
lected. The analysis may be deleted from the file
You requested a tabular report with Difference from reference selected
as one of the columns. This quantity cannot be computed because the
reference file is invalid.
If no reference file has been specified, select one from the Report
Options dialog and re-run the reports. If a file has been specified,
ensure that it contains valid information.
Appendix A
539-42822-01 (Rev A) - Nov 2017