Device Management; Overview; Device Management Configuration; Rebooting The Switch - 3Com Switch 4500 26-Port Configuration Manual

14

Overview

Device Management

Configuration

Rebooting the Switch

Enabling the Timing
Reboot Function
Designating the APP
Adopted when Booting
the Switch Next Time
D M
EVICE ANAGEMENT
With the device management function, the Switch can display the current running
state and event debugging information about the unit, thereby implementing the
maintenance and management of the state and communication of the physical
devices. In addition, there is a command available for rebooting the system, when
some function failure occurs.
The device management configuration task is simple. As far as a user is concerned,
it is mainly to display and debug the device management.
It is necessary to reboot the Switch when failure occurs.
Perform the following configuration in User View.
Table 263 Reboot the Switch
Operation
Reboot the Switch
After enabling the timing reboot function on the Switch, the Switch will be
rebooted at the specified time.
Perform the following configuration in User View, and the
command can be performed in any view.
reboot
Table 264 Reboot the Switch
Operation
Enable the timing reboot function of the
Switch, and set specified time and date
Enable the timing reboot function of the
Switch, and set waiting time
Cancel the parameter configuration of timing
reboot function of the Switch
Check the parameter configuration of the
reboot terminal service of the current Switch
In the case that there are several APPs in the Flash Memory, you can use this
command to designate the APP adopted when booting the Switch next time.
Perform the following configuration in User View.
Command
reboot [ unit unit-id ]
Command
schedule reboot at hh:mm [
yyyy/mm/dd ]
schedule reboot delay { hhh:mm |
mmm }
undo schedule reboot
display schedule reboot
display schedule