Configuring Basic Functions Of Igmp Snooping; Enabling Igmp Snooping - 3Com S7906E Configuration Manual

Configurations made in IGMP snooping view are effective for all VLANs, while configurations made
in VLAN view are effective only for ports belonging to the current VLAN. For a given VLAN, a
configuration made in IGMP snooping view is effective only if the same configuration is not made in
VLAN view.
Configurations made in IGMP snooping view are effective for all ports; configurations made in
Ethernet interface view are effective only for the current port; configurations made in Layer 2
aggregate interface view are effect only for the current interface; configurations made in port group
view are effective only for all the ports in the current port group. For a given port, a configuration
made in IGMP snooping view is effective only if the same configuration is not made in Ethernet
interface view, Layer 2 aggregate interface view or port group view.
For IGMP snooping, configurations made on a Layer 2 aggregate interface do not interfere with
configurations made on its member ports, nor do they take part in aggregation calculations;
configurations made on a member port of the aggregate group will not take effect until it leaves the
aggregate group.

Configuring Basic Functions of IGMP Snooping

Configuration Prerequisites
Before configuring the basic functions of IGMP snooping, complete the following task:
Configure the corresponding VLANs.
Before configuring the basic functions of IGMP snooping, prepare the following data:
Version of IGMP snooping.

Enabling IGMP Snooping

Follow these steps to enable IGMP snooping:
To do...
Enter system view
Enable IGMP snooping globally and
enter IGMP-Snooping view
Return to system view
Enter VLAN view
Enable IGMP snooping in the VLAN
Use the command...
system-view
igmp-snooping
quit
vlan vlan-id
igmp-snooping enable
1-9
Remarks
—
Required
Disabled by default
—
—
Required
Disabled by default