Controlling Route Distribution And Reception; Injecting A Local Ipv6 Mbgp Route; Configuring Ipv6 Mbgp Route Redistribution - 3Com S7906E Configuration Manual

Controlling Route Distribution and Reception

Configuration Prerequisites
Before configuring this task, you need to:
Enable IPv6.
Configure the IPv6 MBGP basic functions.

Injecting a Local IPv6 MBGP Route

Follow these steps to inject a local IPv6 MBGP route:
To do...
Enter system view
Enter BGP view
Enter IPv6 MBGP address
family view
Inject a network to the IPv6
MBGP routing table

Configuring IPv6 MBGP Route Redistribution

Follow these steps to configure IPv6 MBGP route redistribution:
To do...
Enter system view
Enter BGP view
Enter the MBGP multicast
address family view
Enable default route
redistribution into the IPv6
MBGP routing table
Enable route redistribution from
another routing protocol
If the default-route imported command is not configured, using the import-route command cannot
redistribute any IGP default route.
Use the command...
system-view
bgp as-number
ipv6-family multicast
network ipv6-address
prefix-length [ route-policy
route-policy-name | short-cut ]
Use the command...
system-view
bgp as-number
ipv6-family multicast
default-route imported
import-route protocol
[ process-id ] [ med med-value |
route-policy
route-policy-name ] *
1-4
Remarks
—
—
—
Required
Not injected by default
Description
—
—
—
Optional
By default, default route
redistribution is not allowed.
Required
Not enabled by default