3Com S7906E Configuration Manual page 1305

Enabling IPv6 PIM-SM
Configuring the IPv6 SSM Group Range
Configuring IPv6 PIM Common Features
Configuration Prerequisites
Before configuring IPv6 PIM-SSM, complete the following task:
Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-SSM, prepare the following data:
The IPv6 SSM group range
Enabling IPv6 PIM-SM
The SSM model is implemented based on some subsets of IPv6 PIM-SM. Therefore, a router is IPv6
PIM-SSM capable after you enable IPv6 PIM-SM on it.
When deploying an IPv6 PIM-SM domain, you are recommended to enable IPv6 PIM-SM on all
non-border interfaces of routers.
Follow these steps to enable IPv6 PIM-SSM:
To do...
Enter system view
Enable IPv6 multicast routing
Enter interface view
Enable IPv6 PIM-SM
All the interfaces of the same device must work in the same IPv6 PIM mode.
For details about the multicast ipv6 routing-table command, see IPv6 Multicast Routing and
Forwarding Commands in the IP Multicast Volume.
Task
Use the command...
system-view
multicast ipv6 routing-enable
interface interface-type
interface-number
pim ipv6 sm
1-26
Remarks
Required
Optional
Optional
—
Required
Disable by default
—
Required
Disabled by default
Remarks