Configuring The Ipv6 Ssm Group Range; Configuring Ipv6 Pim Common Features - 3Com S7906E Configuration Manual

Configuring the IPv6 SSM Group Range

As for whether the information from an IPv6 multicast source is delivered to the receivers based on the
IPv6 PIM-SSM model or the IPv6 PIM-SM model, this depends on whether the group address in the (S,
G) channel subscribed by the receivers falls in the IPv6 SSM group range. All IPv6 PIM-SM-enabled
interfaces assume that IPv6 multicast groups within this address range are using the IPv6 SSM model.
Perform the following configuration on all routers in the IPv6 PIM-SM domain.
Follow these steps to configure the IPv6 SSM group range:
To do...
Enter system view
Enter IPv6 PIM view
Configure the IPv6 SSM group
range
Make sure that the same IPv6 SSM group range is configured on all routers in the entire domain.
Otherwise, IPv6 multicast data cannot be delivered through the IPv6 SSM model.
When a member of an IPv6 multicast group in the IPv6 SSM group range sends an MLDv1 report
message, the device does not trigger a (*, G) join.

Configuring IPv6 PIM Common Features

Use the command...
system-view
pim ipv6
ssm-policy acl6-number
1-27
Remarks
—
—
Optional
FF3x::/32 by default, here "x"
refers to any legal group scope.