Configuring Ipv6 Multicast Source Port Filtering - 3Com S7906E Configuration Manual

To do...
Configure an IPv6 multicast
group filter
Configuring an IPv6 multicast group filter on a port or a group of ports
Follow these steps to configure an IPv6 multicast group filer on a port or a group of ports:
To do...
Enter system view
Enter Ethernet port/ONU
port/Layer 2 aggregate
interface view or port group
view
Configure an IPv6 multicast
group filter

Configuring IPv6 Multicast Source Port Filtering

With the IPv6 multicast source port filtering feature enabled on a port, the port can be connected with
IPv6 multicast receivers only rather than with multicast sources, because the port will block all IPv6
multicast data packets while it permits multicast protocol packets to pass.
If this feature is disabled on a port, the port can be connected with both multicast sources and IPv6
multicast receivers.
Configuring IPv6 multicast source port filtering globally
Follow these steps to configure IPv6 multicast source port filtering:
To do...
Enter system view
Enter MLD snooping view
Enable IPv6 multicast source
port filtering
Configuring IPv6 multicast source port filtering on a port or a group of ports
Follow these steps to configure IPv6 multicast source port filtering on a port or a group of ports:
To do...
Enter system view
Use the command...
group-policy acl6-number
[ vlan vlan-list ]
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
mld-snooping group-policy
acl6-number [ vlan vlan-list ]
Use the command...
system-view
mld-snooping
source-deny port interface-list
Use the command...
system-view
1-19
Remarks
Required
By default, no group filter is
globally configured, that is,
hosts in VLANs can join any
valid IPv6 multicast group.
Remarks
—
Required
Use either approach
Required
By default, no group filter is
configured on the current port,
that is, hosts on this port can
join any valid IPv6 multicast
group.
Remarks
—
—
Required
Disabled by default
Remarks
—