3Com S7906E Configuration Manual page 1221

<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100, assign ports GigabitEthernet 2/0/1 through GigabitEthernet 2/0/4 to this VLAN, and
enable IGMP snooping and IGMP snooping proxying in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 2/0/1 to gigabitethernet 2/0/4
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] igmp-snooping proxying enable
[SwitchA-vlan100] quit
4) Verify the configuration
After the configuration is completed, Host A and Host B send IGMP join messages for group 224.1.1.1.
Receiving the messages, Switch A sends a join message for the group out port GigabitEthernet 2/0/1 (a
router port) to Router A.
Use the display igmp-snooping group command and the display igmp group command to display
information about IGMP snooping multicast groups and IGMP multicast groups. For example:
# Display information about IGMP snooping multicast groups on Switch A.
[SwitchA] display igmp-snooping group
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port.
GE2/0/1
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
Host port(s):total 2 port.
GE2/0/3
GE2/0/4
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 2 port.
GE2/0/3
GE2/0/4
# Display information about IGMP multicast groups on Router A.
[RouterA] display igmp group
Total 1 IGMP Group(s).
Interface group report information of VPN-Instance: public net
Gigabitethernet2/0/1(10.1.1.1):
(D)
(D)
(D)
1-34