Configuring Static Joining - 3Com S7906E Configuration Manual

S7900e family release 6600 series
Hide thumbs Also See for S7906E:
Table of Contents

Advertisement

Configuring an MLD version on an interface
Follow these steps to configure an MLD version on an interface:
To do...
Enter system view
Enter interface view
Configure an MLD version on
the interface

Configuring Static Joining

After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast
source and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast
data addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.
Follow these steps to configure a static member of an IPv6 multicast group or an IPv6 multicast source
and group:
To do...
Enter system view
Enter interface view
Configure a static member of
an IPv6 multicast group or an
IPv6 multicast source and
group
Before you can configure an interface of an IPv6 PIM-SM device as a static member of an IPv6
multicast group or an IPv6 multicast source and group, if the interface is IPv6 PIM-SM enabled, it must
be an IPv6 PIM-SM DR; if this interface is MLD enabled but not IPv6 PIM-SM enabled, it must be an
MLD querier. For more information about IPv6 PIM-SM and a DR, refer to IPv6 PIM Configuration in the
IP Multicast Volume.
As a static member of an IPv6 multicast group or an IPv6 multicast source and group, an interface does
not respond to the queries from the MLD querier, nor does it send an unsolicited MLD membership
report or a MLD done message when it joins or leaves an IPv6 multicast group or an IPv6 source and
group. In other words, the interface will not become a real member of the IPv6 multicast group or the
IPv6 multicast and source group.
Use the command...
system-view
interface interface-type
interface-number
mld version version-number
Use the command...
system-view
interface interface-type
interface-number
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
1-12
Remarks
Optional
MLDv1 by default
Remarks
Required
By default, an interface is not a
static member of any IPv6
multicast group or IPv6
multicast source and group.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

S7910eS7906e-vS7903eS7903e-sS7902e

Table of Contents