Protocol; Introduction To Protocol Port Security - 3Com 8807 Configuration Manual

8800 series
Hide thumbs Also See for 8807:
Table of Contents

Advertisement

73
Introduction to
Protocol Port Security
Setting the State of
Protocol Port
Set the State of HTTP
Protocol port
P
ROTOCOL
C
ONFIGURATION
The protocol port security function is short for TCP, UDP protocol port close check
function. If a protocol is not enabled, this function can drop the packet whose
destination IP is the virtual interface IP of the switch, so that it reduces the
unnecessary communications between the modules and the CPU operation of the
fabric, and enhances the anti-interference ability of the switch to the packet.
Please perform the following configuration in system view.
Table 807 Set the status of protocol port
Operation
Enable the protocol port security function
Disable the protocol port security function
By default, the protocol port security function is enabled.
At present, the following protocols are being checked:
Table 808 State of the protocol port

Protocol

IGMP/IGSP
OSPF
PIM
SSH
TELNET
HTTP
BGP
MPLS LDP
DHCP
NTP
SNMP-AGENT
RIP
MPLS LDP
RADIUS CLIENT
RADIUS LOCAL SERVER
PORTAL SERVER
Perform the following configurations in system view.
P
S
ORT
ECURITY
Command
ip portsafe enable
undo ip portsafe enable
Port
PROTOCOL:2
PROTOCOL:89
PROTOCOL:123
TCP:22
TCP:23
TCP:80
TCP:179
TCP:646
UDP:67,68
UDP:123
UDP:161
UDP:520
UDP:646
UDP:1812
UDP:1645,1646
UDP:2000
Default State
Close
Close
Close
Close
Close
Open
Close
Close
Close
Close
Close
Close
Close
Close
Open
Close

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 8807 and is the answer not in the manual?

This manual is also suitable for:

88108814

Table of Contents