3Com 8807 Configuration Manual page 105

n
Enabling/Disabling LACP
at Port
Creating/Deleting an
Aggregation Group
"Configuring/Deleting Aggregation Group Description"
■
"Configuring System Priority"
■
"Configuring Port Priority"
■
The active state and inactive state correspond to selected and standby
■
respectively.
When configuring an aggregation group, the status of GVRP feature
■
configured on the master port is reserved, but that on the slave port is disabled.
When adding a port to an existing aggregation group, the GVRP feature on the
■
port is disabled.
When the master port leaves an aggregation group, the status of GVRP feature
■
on both the group and port is reserved; when a slave port leaves an
aggregation group, the GVRP feature on the port is disabled.
When configuring GVRP feature on any port in an aggregation group, the
■
configuration is mapped to the master port of the group.
When querying the GVRP feature configured on any port in an aggregation
■
group, the returned result is about the master port of the group.
For details, refer to the "VLAN&QinQ" part of this manual
You should first enable LACP at the ports before performing dynamic aggregation,
so that both parties can agree on adding/deleting the ports into/from a dynamic
LACP aggregation group.
Perform the following configuration in Ethernet port view.
Table 87 Enabling/disabling LACP on a port
Operation
Enable LACP on a the port
Disable LACP on a the port
By default, LACP is not enabled at the port.
Note that:
You cannot enable LACP at the mirroring port, the port with static MAC
■
address configured, and the port with static ARP configured, port with 802.1x
enabled.
You are inhibited to enable LACP at the port in a manual aggregation group.
■
You can add a port with LACP disabled to a static LACP aggregation group,
■
and then the LACP will be enabled automatically.
You can use the following command to create/delete an aggregation group (for
manual aggregation and static link aggregation). When you delete an aggregation
group, all its member ports are disaggregated.
Perform the following configuration in system view.
Link Aggregation Configuration
Command
lacp enable
undo lacp enable
105