3Com 8807 Configuration Manual page 820

820 C 71: I
HAPTER NFORMATION
n
Sending the
Configuration
Information to Console
terminal
n
C
ENTER
Table 773 Define information source
Operation
Cancel the configuration of information
source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number
except default; level refers to the severity levels; severity specifies the severity level
of information. The information with the level below it will not be output.
channel-number specifies the channel number and channel-name specifies the
channel name.
When defining the information sent to the loghost, channel-number or
channel-name must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring
information source, meantime using the debugging command to turn on the
debugging switch of those modules.
4 Configuring the loghost
The configuration on the loghost must be the same with that on the switch. For
related configuration, see the configuration examples in the later part.
To send configuration information to console terminal, follow the steps below:
1 Enabling information center
Perform the following configuration in system view.
Table 774 Enable/disable information center
Operation
Enable information center
Disable information center
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to console terminal
Perform the following configuration in system view.
Command
undo info-center source { modu-name |
default | all } channel { channel-number |
channel-name }
Command
info-center enable
undo info-center enable