3Com 8807 Configuration Manual page 213

Configuration Tasks
n
Table 182 Configuration tasks
Configuration procedure
Enter system view
Define an ACL and enter ACL view
Define basic ACL rules
Exit ACL view
Apply the ACL in
the snmp-agent
community
command
Apply the ACL in
the snmp-agent
Apply the ACL to
group
control SNMP
command
users
Import the ACL
into the
snmp-agent
usm-user
command
you can apply different ACLs in the snmp-agent community, snmp-agent
■
group and snmp-agent usm-use commands.
You can only apply number-based basic ACLs to implement ACL control over
■
SNMP users.
For the detailed description of these commands, refer to the Command Manual.
Configuring ACL for SNMP Users
Command
system-view
acl number acl-number [
match-order { config |
auto } ]
rule [ rule-id ] { permit |
deny } [ source {
source-addr wildcard | any
} | fragment | time-range
name | vpn-instance
instance-name ]*
quit
snmp-agent community {
read | write }
community-name [
mib-view view-name ] [
acl acl-number ]
snmp-agent group { v1 |
v2c } group-name [
read-view read-view ] [
write-view write-view ] [
notify-view notify-view ] [
acl acl-number ]
snmp-agent group v3
group-name [
authentication | privacy ]
[ read-view read-view ] [
write-view write-view ] [
notify-view notify-view ] [
acl acl-number ]
snmp-agent usm-user {
v1 | v2c } user-name
group-name [ acl
acl-number ]
snmp-agent usm-user v3
user-name group-name [
authentication-mode {
md5 | sha } auth-password
] [ privacy-mode des56
priv-password ] [ acl
acl-number ]
213
Description
-
Required. This command
can only define a
number-based basic ACL.
The acl-number parameter
ranges from 2,000 to
2,999.
Required
-
The SNMP community
name is a feature of SNMP
V1 and SNMP V2. Applying
an ACL in the snmp-agent
community command
filters the network
management systems
based on SNMP V1 and
SNMP V2.
The SNMP group and user
name are features of SNMP
V2 and later. Applying
ACLs in the snmp-agent
group, snmp-agent
group v3, snmp-agent
usm-user, and
snmp-agent usm-user v3
commands filters the
network management
systems based on SNMP V2
and later.
If you apply ACLs in these
two groups of commands
simultaneously, the switch
filters network
management users
according to the both
features.