3Com 8807 Configuration Manual page 741

Setting Lifetime of Trap
Message
Setting the Engine ID of
a Local Device
Setting/Deleting an
SNMP Group
Setting the Source
Address of Trap
Table 681 Set the destination address of trap
Operation
Delete the destination
address of trap
You can use the following command to set lifetime of Trap message. Trap message
that exists longer than the set lifetime will be dropped.
Perform the following configuration in system view.
Table 682 Set the lifetime of Trap message
Operation
Set lifetime of Trap message
Restore lifetime of Trap message
By default, the lifetime of Trap message is 120 seconds.
You can use the following commands to set the engine ID of a local device.
Perform the following configuration in system view.
Table 683 Set the engine ID of a local device
Operation
Set the engine ID of the device
Restore the default engine ID of the device.
The engine ID of the device is in hexadecimal notation and has at least five
characters, which can be IP address, MAC address or self-defined text. It defaults
to the enterprise number + the device information.
You can use the following commands to set or delete an SNMP group.
Perform the following configuration in system view.
Table 684 Set/Delete an SNMP Group
Operation
Set an SNMP group
Delete an SNMP group
You can use the following commands to set or remove the source address of the
trap.
Command
undo snmp-agent target-host host-addr securityname
securityname
Command
snmp-agent trap life seconds
undo snmp-agent trap life
Command
snmp-agent local-engineid engineid
undo snmp-agent local-engineid
Command
snmp-agent group { v1 | v2c } group-name [ read-view read-view
] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-list ]
snmp-agent group v3 group-name [ authentication | privacy ] [
read-view read-view ] [ write-view write-view ] [notify-view
notify-view ] [ acl acl-list ]
undo snmp-agent group { v1 | v2c } group-name
undo snmp-agent group v3 group-name [ authentication |
privacy ]
Configuring SNMP 741