3Com 8807 Configuration Manual page 822

822 C 71: I
HAPTER NFORMATION
Sending the
Configuration
Information to Telnet
Terminal or Dumb
Terminal
C
ENTER
Table 777 Configure the output format of time-stamp
Operation
Configure the output format of the
time-stamp
Output time-stamp is disabled
4 Enable terminal display function
To view the output information at the console terminal, you must first enable the
corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the
console terminal, now you need to use the terminal logging command to enable
the terminal display function of log information on the switch, then you can view
the information at the console terminal.
Perform the following configuration in user view:
Table 778 Enable terminal display function
Operation
Enable terminal display function of debugging
information
Disable terminal display function of
debugging information
Enable terminal display function of log
information
Disable terminal display function of log
information
Enable terminal display function of trap
information
Disable terminal display function of trap
information
By default, the terminal display function of debugging information is disabled.
To send configuration information to Telnet terminal or dumb terminal, follow the
steps below:
1 Enabling information center
Perform the following configuration in system view.
Table 779 Enable/disable Information center
Operation
Enable information center
Disable information center
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
Command
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
Command
info-center enable
undo info-center enable