3Com 8807 Configuration Manual page 772

772 C 67: SSH T
HAPTER ERMINAL
c
S
ERVICE
Table 713 SSH2.0 configuration tasks
Operation
Configure default
authentication type for SSH
users
Configure the updating cycle
of the server key
Configure the SSH
authentication timeout
Configure the number of SSH
authentication retries
Enter public key view
Enter public key edit view to
edit the key
Exit public key edit view
Assign the public key for an
SSH user
Configure first-authentication
SSH server
Configure the SSH
compatibility mode
Configuring the protocol the current user interface supports
Use this configuration task to specify the protocol the current user interface
supports.
Perform the following configuration in VTY user interface view.
Table 714 Configure the protocol the current user interface supports
Operation
Configure the protocol supported by the
current user interface
By default, the system supports all protocols.
CAUTION:
If the supported protocol configured in the user interface is SSH, make sure to
■
configure the authentication mode for logging into the user interface to
authentication-mode scheme (using AAA authentication mode).
If the authentication mode is configured as authentication-mode password
■
or authentication-mode none, the configuration of protocol inbound ssh
will fail, and vice versa.
Command
ssh authentication-type
default [ password | rsa | all
| password-publickey ]
ssh server rekey-interval
hours
ssh server timeout seconds
ssh server
authentication-retries times
rsa peer-public-key
key-name
public-key-code begin
peer-public-key end
ssh user username assign
rsa-key keyname
ssh client first-time enable
ssh server
compatible_ssh1x enable
Command
protocol inbound { all | ssh | telnet }
Description
Required;
By default, users are unable to
log in to the system.
Optional
By default, the system does
not update the server key.
Optional
By default, it is 60 seconds.
Optional
By default, it is three times.
Required
Required
Required
Required
Optional
By default, the system does
not perform the first
authentication.
Optional
By default, the server is
compatible with the SSH1.x
client.