3Com 8807 Configuration Manual page 46

46 C 4: U I
HAPTER SER NTERFACE
n
Configuring Modem
Attributes
C
ONFIGURATION
When a user logs in the switch, the command level that it can access depends on
two points. One is the command level that the user itself can access, the other is
the set command level of this user interface. If the two levels are different, the
former will be taken. For example, the command level of VTY 0 user interface is 1,
however, you have the right to access commands of level 3; if you log in from VTY
0 user interface, you can access commands of level 3 and lower.
Setting the command priority
The following command is used for setting the priority of a specified command in
a certain view. The command levels include visit, monitoring, configuration, and
management, which are identified with 0 through 3 respectively. An administrator
assigns authorities as per user requirements.
Perform the following configuration in system view.
Table 23 Set the command priority
Operation
Set the command priority in a specified view.
Restore the default command level in a
specified view.
Setting input protocol for a user terminal
You can use the following command to set input protocol for a user terminal. The
input protocol type can be TELNET, SSH or all.
Perform the following configuration in user interface view.
Table 24 Set input protocol for a user terminal
Operation
Set input protocol for a user terminal
By default, the input protocol type for a user terminal is all.
When logging in the switch via the Modem, you can use the following commands
to configure these parameters.
Perform the following configuration in AUX user interface view.
Table 25 Configure Modem attributes
Operation
Set the interval since the system receives the
RING until CD_UP
Restore the default interval since the system
receives the RING until CD_UP
Configure auto answer
Configure manual answer
Configure to allow call-in
Configure to bar call-in
Command
command-privilege level level view view
command
Undo command-privilege view view
command
Command
protocol inbound { all | telnet | ssh }
Command
modem timer answer seconds
undo modem timer answer
modem auto-answer
undo modem auto-answer
modem call-in
undo modem call-in