3Com 8807 Configuration Manual page 352

8800 series
Hide thumbs Also See for 8807:
Table of Contents

Advertisement

352
C
32: I
HAPTER
NTEGRATED
Setting IS-IS
Authentication
IS-IS C
ONFIGURATION
Table 328 Set LSP packet retransmission interval
Operation
Set the retransmission interval of the LSP
packet over p2p links
Restore the default retransmission interval of
the LSP packet over p2p links
By default, the LSP packet is transmitted every five seconds over the p2p link.
Configuring number of invalid Hello packets for the interface
The router maintains the adjacency by sending/receiving Hello packets. When
receiving no Hello packets from the peer within a time interval, the local router
regards the neighbors are invalid. The time interval is called Holddown time for the
IS-IS.
Setting invalid number of Hello packets can adjust the Holddown time in the IS-IS.
That is to say, after continuously receiving no specified number of Hello packets,
the router regards the neighbors are invalid.
Table 329 Set number of invalid Hello packets for the interface
Operation
Set the number of invalid Hello packets
Restore the default setting
By default, the number of the invalid Hello packets is set to 3.
If this command does not specify level-1 or level-2, the system regard the invalid
Hello packets are set for both Level-1 and Level-2 routers.
Setting interface authentication
The authentication password set on the interface is mainly used in the Hello
packet so as to confirm the validity and correctness of its peers. The authentication
passwords at the same level of all the interfaces of a network should be identical.
Perform the following configuration in interface view.
Table 330 Set interface authentication password
Operation
Set authentication password
Delete authentication-mode
password
By default, the interface is not configured with any authentication password nor
performs authentication. If the level is not specified, it defaults to setting the
authentication password of Level-1.
Command
isis timer retransmit seconds
undo isis timer retransmit
Command
isis timer holding-multiplier value [ level-1
| level-2 ]
undo isis timer holding-multiplier [ level-1
| level-2 ]
Command
isis authentication-mode { simple | md5 } password [ {
level-1 | level-2 } [ ip | osi ] ]
undo isis authentication-mode { simple | md5 } password [
{ level-1 | level-2 } [ ip | osi ] ]

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

88108814

Table of Contents