3Com 8807 Configuration Manual page 329

Configuring OSPF GR
Perform the following configuration in system view.
Table 302 Configure OSPF MIB binding
Operation
Configure OSPF MIB binding
Restore the default OSPF MIB binding
By default, MIB is bound to the first enabled OSPF process.
Configuring OSPF TRAP
The OSPF Trap function enables the switch to send multiple types of SNMP Trap
packets in case of OSPF process exceptions. In addition, you can specify an OSPF
process ID so that this functions works only on that process. If no process ID is
specified, this function works on all OSPF processes.
Perform the following configuration in system view.
Table 303 Enable/Disable OSPF TRAP function
Operation
Enable OSPF TRAP
function
Disable OSPF TRAP
function
By default, OSPF TRAP function is disabled. That is, the switch does not send TRAP
packets when any OSPF process is abnormal.
For detailed configuration of SNMP TRAP, refer to the module "System
Management" in this manual.
Configuring GR method as RFC3623
Table 304 Configure OSPF GR
Operation
Enter system view
Enter OSPF view
Configure GR
Command
ospf mib-binding process-id
undo ospf mib-binding
Command
snmp-agent trap enable ospf [ process-id ] [ ifstatechange |
virifstatechange | nbrstatechange | virnbrstatechange |
ifcfgerror | virifcfgerror | ifauthfail | virifauthfail | ifrxbadpkt |
virifrxbadpkt | iftxretransmit | viriftxretransmit | originatelsa |
maxagelsa | lsdboverflow | lsdbapproachoverflow ]
undo snmp-agent trap enable ospf [ process-id ] [
ifstatechange | virifstatechange | nbrstatechange |
virnbrstatechange | ifcfgerror | virifcfgerror | ifauthfail |
virifauthfail | ifrxbadpkt | virifrxbadpkt | iftxretransmit |
viriftxretransmit | originatelsa | maxagelsa | lsdboverflow |
lsdbapproachoverflow ]
Command
system-view
ospf [ process-id [ [ router-id
router-id ] vpn-instance
vpn-instance-name ] ]
graceful-restart [ value ]
Configuring OSPF 329
Description
-
-
Required
The time is 120 s by default