3Com 8807 Configuration Manual page 382

382 C 33: BGP C
HAPTER
Setting the Switch for
Adjacency State Output
Clearing BGP Connection
Refreshing BGP Routes
ONFIGURATION
n
Load balancing is not available for BGP default routes.
Perform the following configuration in BGP view.
Table 388 Enable/disable BGP load balancing
Operation
Enable BGP load balancing
Disable BGP load balancing
By default, the BGP does not implement load balancing.
When the switch for adjacency state output is enabled, the BGP adjacency state
changes will be output to the configured terminal until the switch for adjacency
state output is disabled.
Perform the following configuration in BGP view.
Table 389 Set the switch for BGP adjacency state output
Operation
Enter system view
Enter BGP view
Enable the switch for
adjacency state output
After the user changes BGP policy or protocol configuration, they must cut off the
current connection so as to enable the new configuration.
Perform the following configuration in user view.
Table 390 Clear BGP connection
Operation
Clear the connection between BGP and the specified peers reset bgp peer-address
Clear all connections of BGP
Clear the connections between the BGP and all the
members of a group
It is required to re-compute associated route information when BGP routing policy
changes.
Perform the following configuration in user view.
Table 391 Refresh BGP routes
Operation
Refresh general BGP routes
Command
balance balance-number
undo balance
Command
system-view
bgp as-number
log-peer-change
Command
refresh bgp { all | peer-address | group group-name } [
multicast | vpn-instance instance-name | vpnv4 ] { import
| export }
Description
-
Required
The BGP peer changes are not
reported by default
Command
reset bgp all
reset bgp group group-name