3Com 8807 Configuration Manual page 872

872 C 78: P
HAPTER ASSWORD
C C
ONTROL ONFIGURATION
Table 823 Configuring minimum password length
Operation
Enter system view
Configure the minimum
password length
The configuration of minimum password length involves two situations: the global
configuration command can be used in the system view to configure the minimum
length of all user passwords, and the minimum password length can be configure
for a certain user in the user view. Similar to the password aging time
configuration, when the two types of parameters conflict, the parameters
configured in the user view will prevail.
Configuring the maximum number of attempts of entering a password
and the processing mode for failed login attempts
There is a limitation of the number of entering a password. When the number of
attempts exceeds the configured maximum number of attempts, the system will
have three options:
The system will add the user to the blacklist and lock the user for a period of
■
time by putting the user name + IP address and the lock time into the blacklist.
Each time when the user logs in, the system will search in the blacklist. If the
user name and IP address appear in the blacklist, the system will directly
prohibit the user from going into password authentication. After a preset
period of time, the system will remove the user from the backlist and
re-activate the user. The lock time is specified by the system administrator. The
value range is 3 to 360 minutes, and the default value is 120 minutes.
The system will permanently lock the user. In this case, the user can log in again
■
only if he or she is removed from the blacklist and unlocked by the
administrator manually. The blacklist can contain a maximum of 1024 entries.
The system will allow the user to log in again instead of locking him or her.
■
Once the system administrator manually removes locked users from the blacklist,
these user are unlocked and can log in to the switch again.
Table 824 Configuring the maximum number of attempts and the processing mode for
failed login attempts
Operation
Enter system view
Configure the maximum
number of attempts of
entering a password
Configure the processing
mode for failed login attempts
Command
system-view
password-control length
length
Command
system-view
password-control
login-attempt login-times
password-control
login-attempt attempt-time
exceed { lock | unlock |
locktime time }
Description
-
The value range of the
minimum password length is
4 to 32 characters. The
default value is 10 characters.
This command can also be
carried out in user view
Description
-
The value range of the
maximum attempts of
entering a password is 2 to
10; the default value is 3
By default, the system will
lock the user and allow
him/her to log in again a
period of time later