3Com 8807 Configuration Manual page 863

Table 818 Introduction to the configuration tasks of the ICMP test in NQA
Operation
Set the name of the VPN
instance
Set the source IP address of
this test
Set the source interface
Assume the connection mode
between the destination
address and the equipment
enabling the test as direct
connection mode
Set the number of the test
results that can be stored in
the history record
Set the condition (probe) of
sending Trap information to
the network management
system
Set the times of constant
probe fails after which the
Trap information is sent to the
network management system
Set the Trap information filter
condition (test)
Set the automatic test interval frequency interval
Enable the test
Display the test result
Command
vpn-instance name
source-ip ip-address
source-interface {
interface-name |
interface-type
interface-number }
sendpacket passroute
history-records number
send-trap { all | {
probefailure | testcomplete
| testfailure } * }
probe-failtimes times
test-failtimes times
test-enable
display nqa { results |
history } [
administrator-name test-tag ]
NQA Configuration 863
Remarks
Optional;
By default, no name of the
VPN instance is set
Optional;
By default, no source IP
address is configured. The
system uses the IP address of
the source interface as the
source IP address.
Optional;
By default, no source interface
is configured
Optional;
By default, no such
assumption
Optional;
By default, 50 test results can
be stored in the history
record.
Optional;
By default, no Trap
information is sent to the
network management system.
Optional;
By default, the system sends
the Trap information to the
network management system
after one probe fail.
Optional;By default, NQA
sends the Tap information to
the network management
system after one NQA test
fails.
Optional;
The default interval time is 0,
that is, no automatic test is
performed;
Configure the interval>0,
then the system performs one
automatic test every
configured interval time
Required; (ignore this
configuration if you choose
the frequency interval
command to enable the
automatic test); generally, use
this command to enable tests.
The display command can be
executed in any view.