3Com 8807 Configuration Manual page 639

Configuring Routing
Protocols
Configuring Basic MPLS
Functions
Configuring LDP
Expansion Session Peer
Enabling L2VPN
You must perform some basic routing configuration on your switch such that it
can exchange routing information with other P and PE devices. Currently, you can
choose the following routing protocols: static routing, routing information
protocol (RIP), open shortest path first (OSPF), exterior border gateway protocol
(EBGP), and so on. For specific configuration, refer to Switch 8800 Family Series
Routing Switches Operation Manual - Routing Protocol.
Configure basic MPLS functions to create LSP tunnels over public network. For
specific configuration, refer to the "MPLS" section in 3Com Switch 8800 Family
Series Routing Switches Operation Manual Volume I.
Configure LDP remote peer to set up LDP remote session.
Entering the remote-peer mode
Perform the following configuration in system view.
Table 570 Enter the remote-peer mode
Operation
Enter the remote-peer mode
Remove the remote peer
By default, no remote peer exists.
Configuring an address for the remote peer
You can specify any LDP-enabled interface address of a remote peer device or the
loopback address of a label switch router (LSR) that has advertised its routing
information as the address of the remote peer.
Perform the following configuration in remote-peer view.
Table 571 Configure an address for the remote peer
Operation
Configure an address for the remote peer
Enable L2VPN globally before you configure VPLS and VLL; otherwise you cannot
configure VPLS and VLL.
Perform the following configuration in system view.
Table 572 Enable L2VPN
Operation
Enable MPLS L2VPN
Disable MPLS L2VPN
By default, MPLS L2VPN is disabled.
VPLS Basic Configuration
Command
mpls ldp remote-peer index
undo mpls ldp remote-peer index
Command
remote-ip remoteip
Command
mpls l2vpn
undo mpls l2vpn
639