3Com 8807 Configuration Manual page 818

818 C 71: I
HAPTER NFORMATION
C
ENTER
Table 769 Send the configuration information to the trap buffer
Device Configuration
Enable information
center
Set the information
output direction to the
trapbuffer
Switch
Set information source
6 Sending the configuration information to SNMP
Table 770 Send the configuration information to SNMP
Device Configuration
Enable information
center
Set the information
output direction to
SNMP
Switch
Set information source
Configure SNMP
features
Network The same as the SNMP
management configuration of the
workstation switch
Default value
By default, information
center is enabled
-
-
Default value
By default, information
center is enabled
-
-
-
-
Configuration
description
Other configurations are
valid only if the
information center is
enabled
You can configure the
size of the trap buffer at
the same time
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information
Configuration
description
Other configurations
are valid only if the
information center is
enabled
-
You can define which
modules and
information to be sent
out and the time-stamp
format of information,
and so on. You must
turn on the switch of
the corresponding
module before defining
output debugging
information
Refer to Chapter
"SNMP"
-