Kompella Mpls L2Vpn Configuration - 3Com 8807 Configuration Manual

Kompella MPLS L2VPN
Configuration
Configuring Kompella
MPLS L2VPN
Table 566 Configure Kompella MPLS L2VPN
Operation
Enter system view
Configure the LSR ID
Enable MPLS
Enable MPLS L2VPN globally
Perform BGP (border gateway
protocol) related
configuration. Make sure BGP
operates properly and routers
can discover routes to other
routers.
Enter L2VPN address family
view.
Activate the peer or peer
group.
Quit to system view
Create a VPN and specify the
encapsulation type.

Kompella MPLS L2VPN Configuration

Command
system-view
mpls lsr-id lsr-id
mpls
mpls l2vpn
Refer to BGP Configuration in
Routing Protocol module.
l2vpn-family
peer { group-name |
peer-address } enable
quit
mpls l2vpn vpn-name [
encapsulation { ethernet |
vlan } ]
625
Description
-
Required
Required
Required
Required. In a Kompella MPLS
L2VPN, the extended BGP is
used as the signaling protocol
to distribute VC labels. So,
you also need to configure
BGP parameters on PEs. As for
the MPLS L2VPN itself, it has
no special requirements on
the BGP configuration.
Required
Required. By default, only the
peers of BGP IPv4 unicast
address families are active.
The peer groups of other
types are deactivated and thus
cannot exchange the routing
information.
-
Required. The default
encapsulation type is
Ethernet. In the Kompella
mode, the encapsulation type
of the access side of the
private network can be
Ethernet access and VLAN
access. If you configure the
encapsulation type as
Ethernet access, the port link
type in a private network
VLAN is Access type; if you
configure the encapsulation
type as VLAN access, the port
link type in a private network
VLAN is Trunk type. It is not
recommended to use Hybrid
type as the port link type in a
private network VLAN. The
user access modes of the
instance in all the peer PEs
must be consistent.