3Com 8807 Configuration Manual page 829

Table 793 Configure to output information to SNMP NM
Operation
Cancel the configuration of outputting
information to SNMP NM
3 Configuring information source on the switch
By this configuration, you can define the information that sent to SNMP NM is
generated by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 794 Define information source
Operation
Define information source
Cancel the configuration of information
source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number
except default level refers to the severity levels; severity specifies the severity level
of information. The information with the level below it will not be output.
channel-number specifies the channel number and channel-name specifies the
channel name.
When defining the information sent to SNMP NM, channel-number or
channel-name must be set to the channel that corresponds to SNMP direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
n
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring
information source, meantime using the debugging command to turn on the
debugging switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed information.
Perform the following configuration in system view:
Information Center Function
Command
undo info-center snmp channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [
debug { level severity | state state }* | log {
level severity | state state }* | trap { level
severity | state state }* ]*
undo info-center source { modu-name |
default | all } channel { channel-number |
channel-name }
829