3Com 8807 Configuration Manual page 497

Enabling a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family
view.
Table 485 Enable a peer (group)
Operation
Enable the specified peer (group)
Disable the specified peer (group)
Adding an MBGP peer to the group
Please perform the following configurations in IPV4 multicast sub-address family
view.
Table 486 Add an MBGP peer to the group
Operation
Add an MBGP peer to the group
Delete the MBGP peer
Advertising MBGP community attributes to a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family
view.
Table 487 Configure to advertise the community attributes to a peer (group)
Operation
Advertise the community attributes to a peer
(group)
Configure not to advertise the community
attributes to a peer (group)
By default, no community attribute is advertised to any peer (group).
Configuring a peer (group) as an MBGP route reflector client
Please perform the following configurations in IPV4 multicast sub-address family
view.
Table 488 Configure a peer (group) as an MBGP route reflector client
Operation
Configure a peer (group) as an MBGP route
reflector client
Remove the above configuration
By default, there is no route reflector in an AS.
It is generally unnecessary to configure this command for a peer group. This
command is reserved for the occasional compatibility with the network
equipments of other vendors.
MBGP Multicast Extension Configuration
Command
peer group-name enable
undo peer group-name enable
Command
peer peer-address group group-name
undo peer peer-address
Command
peer group-name advertise-community
undo peer group-name
advertise-community
Command
peer group-name reflect-client
undo peer group-name reflect-client
497