3Com 8807 Configuration Manual page 827

Table 788 Enable/disable information center
Operation
Enable information center
Disable information center
n
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to the trap buffer
Perform the following configuration in system view.
Table 789 Configure to output information to trap buffer
Operation
Output information to trap buffer
Cancel the configuration of outputting
information to trap buffer
By default, the switch outputs information to the trap buffer in the CPU. The size
of the trap buffer is 256, that is, the trap buffer can hold up to 256 messages.
3 Configuring information source on the switch
By this configuration, you can define the information that sent to trap buffer is
generated by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 790 Define information source
Operation
Define information source
Cancel the configuration of information
source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number
except default; level refers to the severity levels; severity specifies the severity level
of information. The information with the level below it will not be output.
channel-number specifies the channel number and channel-name specifies the
channel name.
When defining the information sent to trap buffer, channel-number or
channel-name must be set to the channel that corresponds to trapbuffer direction.
Information Center Function
Command
info-center enable
undo info-center enable
Command
info-center trapbuffer [ size buffersize |
channel { channel-number | channel-name }
]*
undo info-center trapbuffer [ channel |
size ]
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [
debug { level severity | state state }* | log {
level severity | state state }* | trap { level
severity | state state }* ]*
undo info-center source { modu-name |
default | all } channel { channel-number |
channel-name }
827